What should I photograph after water damage?
Photograph every affected room wide and then close, the source of the water, any visible water line, wet materials before they are removed, damaged contents where they stand, and any meter or gauge reading. Take the pictures before anything is moved. Keep the original files on something that did not get wet.
Work around each room in order, starting from the doorway, so the sequence of images matches the layout. Then come in close on the specifics: a swollen baseboard, a stopped appliance, a broken fitting, a stained ceiling.
A short narrated video walk-through helps an adjuster understand how rooms connect, but it does not replace stills. Avoid filters, crops and edits, which raise questions you do not need.
- Every room, wide and then close
- The source: pipe, hose, appliance, roof, doorway
- Water lines on walls, doors and furniture
- Contents in place, before they are moved
- The moisture meter display during readings
Do moisture readings matter as much as photographs?
They answer a different question. A photograph shows a stain; a reading shows whether the material behind it is wet, how wet and when it became dry. Readings are what justify the rooms that were dried and the days equipment ran, and they are the only proof that the structure was dry before anything closed it up.
Ask for the log at the end of the job, showing readings per room and per visit. A crew that cannot produce one has not demonstrated that the building is dry.
The readings also protect you later. If a floor cups or a wall grows something months afterwards, a dated log showing dry readings on completion is the difference between a clear history and a guess.
Should I start drying before the adjuster sees it?
Photograph first, then act. Insurers generally expect a policyholder to take reasonable steps to prevent further damage after a loss, and leaving water in a building for days is not one of them. Record the condition, stop the water, begin extraction and drying, and tell your insurer what you are doing as early as you can.
Mitigation is not repair. Removing water, taking out soaked material and running equipment is limiting the loss; rebuilding is a separate stage that can wait for the claim to progress.
Keep every receipt from the first hours, including things you bought yourself. Note who you spoke to at the insurer and when, in writing, on the same day.
Where do I go if there is a problem with my insurer or contractor?
The Illinois Department of Insurance is the state regulator for insurance in IL, and it also licenses public adjusters, so it can confirm whether someone offering to handle your claim is licensed. For a problem with a contractor, the Illinois Attorney General takes consumer complaints. Ask for the insurer's reasons in writing first.
This page does not give legal or claims advice, and it states no deadlines, limits or amounts. Ask the regulator or your own adviser about anything time-sensitive, and do it early rather than at the end.
On the contractor side, IL requires a written contract signed by both parties before the work starts. If you have no written scope, you have nothing to compare the invoice against. The guide on hiring a water damage contractor sets out what to ask for.
What affects the cost of a documented restoration job?
The same things that affect the work itself: the area affected, how much material has to come out, how many rooms need equipment and for how many days, access, and whether the water was clean or contaminated. Documentation is part of the job rather than an add-on. The scope is explained and approved before work begins.
No figures are published on this site, because a quote depends on what a technician finds in your building. What you can insist on is a written scope before the work and an invoice that matches it afterwards, line for line.
Good records tend to reduce argument rather than add to the bill, because every item is attached to a photograph, a reading or a day of equipment. The guide on what moves a restoration quote explains the variables.