How soon does mold start after water damage?
Growth can begin on wet material within a couple of days, given ordinary indoor warmth. It is not a fixed clock: it depends on the material, the temperature and whether air is moving. The practical rule is that material dried in the first day or two usually stays material, and material still wet after a week usually does not.
This is why a crew is dispatched as fast as one is available rather than booked for next week, and why the pumping and the drying are treated as one job rather than two.
It is also why a basement that was emptied of water but never dried so often produces a call a month later. The visible water left; the water in the slab, the wall base and the framing did not.
Can I clean it myself with bleach?
Wiping a hard surface is reasonable for a small spot you can see and reach. It will not help on drywall, insulation or carpet pad, where the growth is in the material rather than on it, and a wet wipe-down adds water. Nothing applied to a surface fixes a wall that is still wet behind it.
The other problem with cleaning first is that it destroys the record. Photographs taken before anything is touched are what an adjuster and a crew both work from later.
Where growth covers more than a small patch, or where it is on material that has to be removed anyway, containment and filtered air matter, because dry removal moves a great deal of dust around a house.
Does the drywall always have to come out?
Not always. Drywall that was wet but has no growth and dries to normal readings can usually stay, which is why the readings are taken before the saw comes out. Board whose paper facing is colonized, or that is soft, delaminated or was soaked by contaminated water, is removed with a margin beyond the visible growth.
The judgment is about the material, not the stain. A dry, firm, stained board is a decorating question. A soft board with growth on the back is a removal question.
Where board is cut, the cut is made at a sensible line for rebuilding and the cavity behind it is dried and cleaned before anything closes it up again. See ceiling and drywall water damage.
Who regulates this work in Illinois?
Requirements vary by municipality rather than being uniform across the state, so the right first call is your local building department, which can tell you what applies at your address and whether a permit is needed for the rebuilding that follows. Ask any contractor what they intend to do and get it in writing before work starts.
In IL a written contract signed by both parties is required before work begins, and that contract is the place where the scope, the containment and the drying are spelled out. A verbal promise to treat a basement is not a scope of work.
Complaints about a contractor can be raised with the Illinois Attorney General, which takes consumer complaints. The guide on hiring a water damage contractor covers what to ask and what to keep.
What changes the size of a mold job here?
The square footage affected, how much of it is inside cavities rather than on surfaces, whether the water was clean or contaminated, and how long it ran before anyone looked. Access and the need to keep the rest of the house usable also matter. The scope and the price are explained and approved before work starts.
Time is the factor a household controls. Growth found in week one is a contained patch; the same leak found after a wet season has reached insulation, framing and more than one room.
Waukegan's mix of pre-war and postwar housing adds variation. Plaster on lath, later finishes over older walls, and additions built to a different standard all change how much has to be opened to reach the wet material. Waukegan Water Damage Restoration measures the area, writes the scope down and starts only once it is agreed.