Des Plaines River Flood Damage in Russell
The river crested at 12.15 feet at Russell in July 2017, over a foot above the 2004 record.
Phones answered 24/7 across Russell. Call for a clear price before any work starts.
Fastest: call (833) 490-5225. Or send this and we call you back.
Russell sits on the Des Plaines River, and Waukegan Water Damage Restoration answers water damage calls from it at any hour. A crew is dispatched as fast as one is available to stop the source, pump out standing water and dry the structure until repeat readings hold at target.
Russell is a very small village on the Des Plaines River in the north of Lake County, upstream of Gurnee and about fourteen kilometers from Waukegan, with ZIP 60075. The river is the one thing the record is firm about. National Weather Service preliminary figures list a crest of 12.15 feet at Russell on July 14, 2017, against a previous record of 11.09 feet set in 2004, and NWS flood warnings have covered the river near Gurnee and Russell. The NWS puts flood stage for the Des Plaines from Libertyville down to Prospect Heights at 12.5 feet.
Beyond the river gauge, this page is deliberately short on local detail. No housing information and no damage record were found for Russell, so nothing is said here about how its buildings are built or what water has done to them before. That is a gap in the research, not something to be filled in with plausible guesses, and the work does not depend on closing it: the source, the soaked materials and the standing hours are read on arrival.
Local weather drives activity here: heat, humidity and rain change what shows up week to week.
It tells you that the ceiling has moved. A crest of 12.15 feet at Russell on July 14, 2017 beat the previous record of 11.09 feet from 2004 by more than a foot, which means the highest water anyone here had planned around was exceeded within living memory. Those are preliminary National Weather Service figures, and they are the most specific piece of information this site holds about Russell.
It also tells you when to start paying attention. The NWS gives flood stage for the Des Plaines from Libertyville to Prospect Heights as 12.5 feet, and issues flood warnings that name the river near Gurnee and Russell. A warning on this stretch is the moment to lift what can be lifted off a lower floor, not the moment to go and look at the water. River work after the fact is Des Plaines River flood damage, and the first-hours sequence is in the guide on what to do first in a Des Plaines flood.
Because of what is in it. Water from a supply line is clean when it arrives and the question is only how far it traveled. River water that has crossed ground, roads and whatever the catchment drains is not clean, and it is not dried and left in place. Porous material it soaked through, including carpet pad, insulation and the lower band of drywall, generally comes out rather than being dried, and hard surfaces are cleaned before anything is dried.
That is also why nobody should be wading through it to save boxes. Standing floodwater hides what it is standing on, it can be in contact with circuits, and it carries whatever it picked up upstream. The practical rule for a river property is to leave the water alone, get the power to the wet level turned off at the panel if that can be done safely and dry, and let the crew pump before anybody goes back in.
The water leaves first, by pump for volume and by extraction for what the pump cannot reach. Then the building is opened where it has to be: base and trim off, drilled or cut access into cavities that hold water, carpet and pad gone if the water was dirty or has sat. Only after that does drying equipment make sense, because fans blowing across a sealed wet cavity achieve very little.
From there it is numbers. Moisture meters read framing, subfloor and drywall at marked points, the readings are written down, and air movers and dehumidifiers run until the numbers stop falling and hold. Where they stop falling early, something is still wet behind a surface that was not opened. The equipment side of this is set out in structural drying and dehumidification, and the written record it produces feeds insurance claim documentation.
No. The phones are answered 24/7 on (833) 490-5225 and a crew is dispatched as fast as one is available, with no arrival time quoted, which is the same answer a caller in Waukegan gets. The thing that genuinely affects a Russell call is not village size but the weather that caused it: when a river crest is working its way down the Des Plaines, a lot of properties on that stretch call within the same few hours.
That is the argument for calling as soon as water is in rather than waiting until it has stopped arriving. The call gets logged, the questions get asked, and you get the instructions that protect the building and the later claim in the meantime: main valve off, nothing moved before it is photographed, no circuits used on the wet level, and anything portable lifted clear.
The river crested at 12.15 feet at Russell in July 2017, over a foot above the 2004 record.
River water is pumped out by volume before any part of the building can be opened or read.
Water that has come up a drain is handled as contaminated, whatever the river is doing.
Framing and subfloor soaked by river water are dried to measured targets, not to a schedule.
A rural property found wet days later is the case where mold has already had its conditions.
Photographs before anything moves and written readings are what a river loss claim rests on.
Call any hour and explain what is going on. You get a clear price before any work starts.
Russell ZIP codes we cover: 60075. Type yours to confirm, or just call.
National Weather Service preliminary figures list a crest of 12.15 feet on July 14, 2017, against a previous record of 11.09 feet in 2004. Flood warnings on this stretch name the river near Gurnee and Russell.
The National Weather Service gives 12.5 feet for the Des Plaines from Libertyville down to Prospect Heights. A warning is the point to move belongings up, not the point to go and look at the water.
Because no housing or damage information was found for the village. Rather than describe buildings nobody here has surveyed, this page sticks to the river gauge, which is sourced, and to how the work is done.
Not usually. River water is not clean, so soaked porous material such as carpet pad, insulation and the lower band of drywall generally comes out, and hard surfaces are cleaned before drying starts.
Pumping a lower level while the ground outside is still saturated can do more harm than good, and standing water may be in contact with circuits. Get the power to that level off safely if you can, then let a crew pump.